Recording Procedure - Technics SX-KN7000 Operating Instructions Manual

Part V

Recording procedure

1.
In the START RECORDING area on the dis-
play, select the rhythm part you want to record
first.
BAS: BASS
AC1– 5: ACCOMP 1– 5
DR1, 2: DRUMS 1, 2
• The metronome sound starts and the display
looks similar to the following.
2.
Adjust the tempo.
• The tempo is shown on the display as
• The tempo can be freely adjusted when you
play back the rhythm pattern, so record at the
tempo which is easiest for you to play.
3.
Select the sound.
• For the DRUMS part, only sounds from the
DRUM KITS sound group can be selected.
• For the ACCOMP and BASS parts, select
sounds from groups other than the DIGITAL
DRAWBAR/ORGAN TABS sound groups.
4.
Record the part.
• The specified number of measures are re-
peatedly played back, during which time any
newly played notes are added to those already
recorded. The current measure number is
shown on the display as "MEASURE=".
• Record the performance in C major for correct
chord progressions during playback. Follow
the KEY SETTING procedure if you wish to
record the performance in a different scale.
112
QQTG0671
• PITCH BEND, MODULATION (except for the
DRUMS part) effects are also recorded.
• The SUSTAIN ON/OFF is also stored (except
for the DRUMS part).
Button functions
PART BALANCE:
Adjust the volume of each part on the PART
BALANCE display. (These settings are not re-
corded.)
PART SETTING:
You can make detailed settings for each part.
(Refer to page 114.)
STEP RECORD:
Change to the STEP RECORD mode. (Refer
to page 116.)
SOLO:
Mute all parts except the part which is currently
being recorded.
• A MUTE mark is shown for the other parts on
the display.
• To turn off the SOLO function, press this but-
ton again.
=.
PART CLR:
Erase all recorded contents of the currently
selected part.
NOTE CLR:
Data is erased one note or one percussion in-
strument (DRUMS part) sound at a time.
• Hold and press this button, and press the key-
board key that corresponds to the note or
percussion instrument (DRUMS part) sound
you wish to erase.
ALL ERAS:
The performance recorded in the selected part
is erased for as long as this button is pressed.
QUANTIZE:
Smooth out any unevenness in the timing of
your performance.
• Before recording, use the QUANTIZE
∨
buttons to select the note value for the
desired quantize level. (The quantize level is
shown on the display as QUANTIZE=.)
KEY IN CHORD MODIFY (except for INTRO,
ENDING, DRUMS):
Use the GROUP and TYPE
to select the type of pattern progression.
• This setting is for the sound that is going to
be recorded from this time.
Composer
∧
and
∧ ∨
and buttons