Part Setting - Technics SX-KN7000 Operating Instructions Manual

Part XIII

Part Setting

Follow this procedure to set the functions which can be set for each part: MIDI CHANNELs, the OCTAVE
data to NOTE data during transmission, and LOCAL CONTROL (whether or not the sound generator of
this instrument is active during transmission).
1.
On the MIDI MENU display, select PART SET-
TING.
• The display looks similar to the following.
Use the PART L and M buttons to select a
2.
part.
• The list of parts covers 4 pages. Use the
OTHER PARTS/TR button or PAGE button to
view different parts.
∧
3.
Use the CHANNEL
a MIDI CHANNEL for the part (OFF, 1 to 16).
• A part which has been set to OFF cannot be
used to transmit or receive MIDI data.
• The initialized settings are as follows:
RIGHT 1 1
RIGHT 2 2
LEFT 3
PART 1 OFF
PART 2 OFF
PART 3 OFF
PART 4 4
PART 5 5
PART 6 6
PART 7 7
PART 8 8
PART 9 9
PART 10 10
PART 11 11
PART 12 12
PART 13 13
PART 14 14
PART 15 15
PART 16 16
CONTROL OFF
ACCOMP 1 – 5 OFF
190
QQTG0671
∨
and buttons to select
BASS OFF
DRUMS 1 – 2 OFF
CHORD OFF
∧
4.
Use the OCTAVE and
octave shift value (– 3 to 3).
• Octave shift is set for transmitted data only;
however the transmitted and received octave
shifts are linked. For example, if the trans-
mitted octave shift is set to 1, the received
octave shift is automatically set to – 1.
∧
5.
Use the LOCAL and
disable this instrument's sound generator.
• When set to ON, the performance from this
instrument is transmitted as MIDI data and
also sounds from this instrument. When set to
OFF, the performance from this instrument is
transmitted as MIDI data but does not sound
from this instrument.
6.
Repeat steps 2 to 5 for each part as desired.
MIDI
∨
buttons to set the
∨
buttons to enable or