Chord Modify Change - Technics SX-KN7000 Operating Instructions Manual

Part V
5.
Use the buttons below the display to switch to
a different recording part, and proceed to re-
cord each part in turn.
6.
When you have finished recording the rhythm,
turn off the PROGRAM MENUS button.

Chord Modify Change

For data that has already been recorded, you can select the type of pattern progression for the bass
and accomp parts.
• This function cannot be used for the INTRO and ENDING patterns.
1.
On the RECORDING display, press the
CHORD MODIFY CHANGE button.
• The display looks similar to the following.
Use the PART L and M buttons to select the
2.
part you wish to set.
3.
Use the GROUP and CHORD MODIFY TYPE
∧ ∨
and buttons to select the corresponding
progression type.
• If a progression type for which the note name
is displayed (in C key) was selected for the
chord group, played notes which are not dis-
played are changed to notes which are dis-
played.
∧
4.
Use the FUNCTION
or disable the function.
KEEP: No change.
CHANGE: The change is enabled.
5.
When you have finished making the settings
for each part, press the OK button.
6.
Press the EXIT button.
∨
and buttons to enable
Composer
113
QQTG0671