Technics SX-KN7000 Operating Instructions Manual page 180

Part XI
P. MEM BANK DEC.:
Change to the previous PANEL MEMORY
bank in order.
PANEL MEMORY 1 to 8:
The specified PANEL MEMORY number is
turned on.
P. MEM INC.+DEC.:
Press the switch to increment the PANEL
MEMORY number selection by one; release
the switch to return to the previous number.
START/STOP:
START/STOP button on/off
FILL IN 1:
FILL IN 1 button on
FILL IN 2:
FILL IN 2 button on
INTRO & ENDING 1:
INTRO & ENDING 1 button on
INTRO & ENDING 2:
INTRO & ENDING 2 button on
SUSTAIN:
SUSTAIN button on/off
GLIDE:
Glide on/off (The glide effect "bends" the pitch
down by about one semitone.)
TECHNI-CHORD:
TECHNI-CHORD button on/off
DIGITAL EFFECT:
DIGITAL EFFECT button on/off
SOUND DSP:
SOUND DSP button on/off
SOUND DSP VARI:
SOUND DSP VARIATION button on/off
ROTARY SLOW/FAST:
TREMOLO SLOW/FAST of the DIGITAL
DRAWBAR/ORGAN TABS
MIC REVERB & EFF.:
MIC effect on/off
PUNCH RECORD:
Punch in/punch out
180
QQTG0671
APC HOLD:
Memorize the chord specified for the automat-
ic accompaniment.
FADE IN:
FADE IN button on/off
FADE OUT:
FADE OUT button on/off
PAD 1 to 6:
Specified PERFORMANCE PADS on
TAP TEMPO:
TAP TEMPO button on.
EXPRESS. PEDAL
TOTAL EXPRESSION:
The volume for all parts changes when the ex-
pression pedal is operated.
PART EXPRESSION:
The volume changes only for parts for which
PART EXP PEDAL was turned ON on the
PART SETTING display for SOUND. (Refer to
page 155.)
• The initialized settings are as follows:
FOOT SWITCH 1 SUSTAIN
FOOT SWITCH 2 GLIDE
FOOT CONT. SW 1 START/STOP
FOOT CONT. SW 2 P.MEM INCREMENT
FOOT CONT. SW 3 P.MEM DECREMENT
FOOT CONT. SW 4 P.MEM BANK INC.
EXPRESS. PEDAL TOTAL EXPRESSION
• For connection of a Foot Switch, etc., refer to
page 199.
Control