Tone Edit - Technics SX-KN7000 Operating Instructions Manual

Part X

Tone Edit

Modify the separate tones which comprise the sound.
About tones
A sound may be made up of at most four tones.
SOUND
TONE SELECT
1.
On the SOUND EDIT menu, select TONE.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select the tone you wish to edit (1st, 2nd, 3rd,
4th).
• Use the ON/OFF buttons to select ON or OFF.
3.
Select a sound for the tone.
∧
• Use the GROUP
and
group, and the TONE NAME
to select the sound.
• A "
" mark in the TONE DYNAM column indi-
*
cates that a TONE DYNAMICS change was
made to the sound.
∧
4.
Use the LEVEL and
volume.
∧
5.
Use the KEY and
of the output sound.
∧
6.
Use the DETUNE
adjustment of the pitch deviation.
166
QQTG0671
1st tone
2nd tone
3rd tone
4th tone
∨
buttons to select the
∧ ∨
and buttons
∨
buttons to adjust the
∨
buttons to set the pitch
∨
and buttons for fine
• A special process is used to produce real-
sounding piano type tones. For this reason,
some edit procedures for piano sounds, FIL-
TER or AMPLITUDE for example, may differ
from those for other sounds.
∧
7.
Use the PANNING
the stereo balance.
• PAN: CTR is the center point. At L64, the
sound is all the way to the left, at R63 all the
way to the right.
• If STEREO R or STEREO L is selected for the
MODE, the balance is fixed (cannot be
moved).
∧
8.
Use the DELAY and
delay time of the sound.
• The higher the number, the longer the delay
before sound output.
∧
9.
Use the TRIGGER
a trigger mode.
KEY ON:
The normal mode, in which sound is emitted
when the key is played.
KEY OFF:
Sound is emitted when the key is released (like
muted strings, for example).
LEGATO:
Sound is emitted only when the key is played
legato.
NON LEG:
Sound is not emitted when the key is played
legato.
PEDAL:
The sound is produced only while the SUS-
TAIN button is on.
Sound Edit
∨
and buttons to adjust
∨
buttons to adjust the
∨
and buttons to select