Advertisement
L
IQUID VACUUM OPERATION
1
2
3
6
LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO;
LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL
OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER SOCKET, MAKE SURE
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET AND DRY VACUUM
CLEANER.
1. Verify that the power cord is disconnected from the power socket. Verify that the
2. Remove all filters and dispose of properly.
3. Rinse out the inside of tank to remove any loose debris and dispose of liquid in
5
4
4. Then carefully install the foam sleeve filter over the filter cage and place the power
DO NOT USE THE HEPA FILTER FOR LIQUID VACUUMING
tank is clean and free of dust and dirt. (fig. 1)
suitable container.
head back on the tank. (fig. 2) See filter installing instructions on page 10.
WARNING:
IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY
MUST BE DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING
OPERATIONS.
OPERATING INSTRUCTIONS – WET VACUUMING
1. Fit the desired nozzle to the vacuum cleaner hose. (fig. 3)
2. Verify that the switch is in the 'O' OFF position before plugging the power cord into
the power socket. (fig. 4)
3. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 5)
4. After use, empty the tank by unscrewing the drain cap. Drain liquids into a suitable
receptacle or drain. Remember to refit the drain cap to the tank after draining tank.
(fig. 6)
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the
nozzle completely in the liquid; leave a gap at the tip of the nozzle opening to allow
air inflow. The machine is fitted with a float valve that stops the suction action when
the container reaches its maximum capacity. You will notice an increase in motor
noise.
When this happens, turn off the machine, disconnect from power supply, and drain the
liquid into a suitable receptacle or drain. To continue vacuuming, refit the container
with the drain cap. After wet vacuuming, turn the machine off and remove plug from
power supply. Empty the container, clean and dry the inside and outside before storage.
REMEMBER!
The foam filter must be removed after wet vacuuming, and the
HEPA filter must be reinstalled before dry vacuuming again.
8
Advertisement
