Advertisement
I
NSTALLING & CLEANING FOAM SLEEVE FILTER
1
2
3
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the power socket. (fig. 1)
2. Remove power head and place in an upside down position.
Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole is
covered. (fig. 2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam
sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean
water. (fig. 5)
3. Allow filter to air dry before installing and using again.
W
HEN TO CHANGE FILTERS
Change the collection bag
When the collection bag is 3/4 full, it MUST be replaced. Excessive over filling of this
bag makes it difficult to remove from the vacuum cleaner tank and can result in
breakage and spills. The collection bag comes equipped with a quick closing flap.
When collection bag becomes 3/4 full, turn off vacuum cleaner and slowly remove the
collection bag from the tank until the opening in the collection bag is clear of the
tank. Pull the closure slide up on the collection bag, which will close the opening.
Hazardous materials must be disposed of properly. NEVER throw contaminated debris
in your usual trash receptacle. Place closed collection bag in an approved poly bag or
container marked with HAZARDOUS MATERIAL warning and dispose in accordance
with your local Hazardous Waste Regulations.
4
5
Change the pre-filter
The pre-filter should be replaced with every fifth change of collection bag and whenever
there is damage or a visible collection of debris on the outside of the filter.
Change the HEPA filter
Replace the HEPA filter when loss of vacuum continues to occur after you have checked
for an obstructions in the hose or wand. Also, install a new collection bag and pre-filter.
T
ROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
TROUBLESHOOTING.
Symptom
Possible Causes
1) No power supply.
Vacuum
2) Faulty power cord.
cleaner will
3) Tank full.
not operate.
1) The cartridge filter is
Dust comes
missing or damaged.
out from
2) HEPA cartridge filter is
motor cover.
not installed correctly.
1) There is a blockage
Reduced
in the nozzle, hose,
efficiency and
or the container inlet.
motor/speed
The cartridge filter is
vibration.
clogged by fine dust.
Corrective Action
1) Check power supply – cord, breakers, fuses.
2) Unplug and check the power cord. If
damaged, have it repaired by a professional.
3) Empty tank.
1) Attach or replace cartridge filter.
2) Please make the screw down to
fix the HEPA cartridge filter.
1) Check nozzle, hose and container
inlets for blockage.
Take off the filter and clean it.
Or install a new cartridge filter.
10
Advertisement
