Stringing The Frame - Gamma 6500 Els Owner's Manual

string from tensioner, and proceed to thread string into next sets of holes. After the last main
strings are pulled, tie-off the strings at the appropriate hole specified by the racquet
manufacturer.
MOUNTING THE FRAME
Securing the Racquet Hold Down
Depress the racquet hold down lever to secure the
racquet frame.

STRINGING THE FRAME

Installing the Main Strings
To begin stringing the main strings, insert the
two ends of the string through the two
center holes at the appropriate end of the
frame and continue through the center holes
on the opposite end of the racquet.
Secure one of the strings using a string
clamp and insert the free end into the string
gripper.
When tension is apllied to the string, clamp
off the tensioned section of string, release
Installing the Cross Strings
Weave the cross strings over and under the
main strings being careful to alternate the
weave direction of each consecutive cross
string so as to be opposite of the previously
installed cross string.
Once the final cross string is tensioned and
clamped, tie off at the appropriate hole speci-
fied by the racquet manufacturer.
Remove the strung racquet by loosening the
shoulder supports and support slides in small
increments until the racquet is free from the
mounting system.
15