NordicTrack E10 REAR DRIVE NTEVEL89909.2 User Manual page 24

HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first unplug the power cord.
Using a flat screwdriver, release the tabs on the
Access Cover (20) and pry the Access Cover upward
off the elliptical.
152
13
153
50
Next, lift the Latch (50) on the underside of the Left
Pedal Arm (13), and then lift the Left Pedal Arm off the
left Pedal Arm Sleeve (46).
20
19, 18
46
153
Then, remove the M4 x 16mm Round Head Screws
(152), the M4 x 42mm Screws (153), and the M4 x
25mm Screw (162) from the Right and Left Shields
(18, 19). (Note: Not all Screws are shown. Be sure to
note which size Screws come from which holes.) Then,
carefully remove the Left Shield.
Loosen the Pivot Screw (97). Tighten the Belt
Adjustment Screw (85) until the Drive Belt (38) is tight.
When the Drive Belt is tight, tighten the Pivot Screw.
When you are finished, reattach the left shield, replace
the left pedal arm, and reattach the access cover.
Then, plug in the power cord.
24
38
97
85