NordicTrack E10 REAR DRIVE NTEVEL89909.2 User Manual page 10

9. Orient the Ramp Cover (131) around the Upright
(5) as shown.
Press the tabs on the Ramp Cover (131) into the
Ramp (130).
10. Apply grease to a Link Arm Axle (114).
Insert the Link Arm Axle (114) into the Right
Upper Body Leg (6) and the Right Link Arm (43)
from the side shown.
Insert a hex key into the M8 x 35mm Screw
(149) in the Link Arm Axle (114).
Using a second hex key, tighten another M8 x
35mm Screw (149), a Small Axle Cover (56),
and an M8 Washer (95) into the other end of the
Link Arm Axle (114). Tip: Avoid damaging the
Small Axle Cover when tightening the Screw.
Repeat this step on the other side of the
elliptical.
9
131
10
149
10
5
130
Grease
6
114
95
56
43
149