Storeonce 3500 Series; Storage Expansion; Optional Hardware; Front And Rear Views - HP StoreOnce 3100 System Installation And Configuration Manual

StoreOnce 3500 Series

Storage expansion

The StoreOnce 3500 Series does not support the addition of storage expansion enclosures. It
is supplied with 12 disks installed.
The StoreOnce 3540 model is supplied with twelve 4–TB disks installed.
The StoreOnce 3520 model is supplied with twelve 2–TB disks installed.
The base configuration for both models uses 50% of the available capacity (24 TB or 12 TB). If
configured in the factory for the full capacity of 48 TB (3540 model) or 24 TB (3520 model), all
storage will already be licensed. If not factory configured, the license entitlement will be delivered
to the user via email.
IMPORTANT:
configuration task is to apply the license for the additional capacity, as described in

Optional hardware

The StoreOnce 3500 Series provides four PCIe slots for the addition of StoreOnce 10 GbE or
10 GbE-T Network Cards or StoreOnce 8Gb Fibre Channel cards. These additional PCIe cards
may be pre-installed or supplied in separate boxes. Some cards also require SFP+ transceivers,
which will be supplied with the kit.
IMPORTANT:
Card Installation and Configuration Guide for detailed instructions about installing and cabling
optional PCIe cards and make sure the correct SFP+ transceivers are fitted, if required.

Front and rear views

Figure 13 StoreOnce 3500 Series front view
1 NIC status LED
3 Power on/standby button and system power LED
56 Hardware overview reference section
When increasing storage capacity from 50% to 100%, the only installation and
Refer to the StoreOnce 10 GbE Network Card and StoreOnce Fibre Channel
1 2 3 4
2 Health LED
4 UID button LED
(page 25).