Ilo Functionality; Ilo Network Name And Ilo Password; To Configure Ilo4, All Systems - HP StoreOnce 3100 System Installation And Configuration Manual

Figure 6 Powering up HPE StoreOnce 3500 Series and 5100 System
1 System health LED
3 NIC status LED

iLO functionality

StoreOnce Systems are built on ProLiant server hardware and use the embedded Integrated
Lights-Out 4 (iLO 4) management technology. iLO enables secure remote monitoring and console
access via a web browser.
iLO is not required for daily management of the StoreOnce appliance but is useful in a lights-out
data center situation. iLO is also useful for diagnosing hardware failures that prevent access to
the appliance through the primary StoreOnce GUI or remote StoreOnce CLI interface.

iLO network name and iLO password

All StoreOnce Systems described in this guide are supplied with a label that includes the iLO
network name and iLO password. Ideally, the installer has made a note of this information, as
recommended in Step 3 of the printed Start Here guide. If not, it will be necessary to locate the
label on the top of the appliance in the data center.
It is good practice to either change the password after installation, or define an additional user
with privileges that can be used when accessing iLO from a web browser.

To configure iLO4, all systems

1. Boot up the StoreOnce System and watch the local console; the iLO4 IP addresses are
shown (IPv4 and IPv6).
NOTE:
will be shown here and you can connect to the network address in a web browser in order
to configure iLO.
2. If there are no DHCP–assigned IP addresses, you can manually configure iLO using the
local console. Press F9 in the ProLiant POST screen to access System Utilities. Select
System Configuration.
18 Powering up and setting up iLO4
If the iLO port is plugged into a network that provides DHCP, the acquired addresses
1
2
3
4
2 Power LED and on/off button
4 UID LED