Storeonce Gui; Modify The Snmp Agent Setup - HP StoreOnce 3100 System Installation And Configuration Manual

1. Define the host to which the SNMP agent sends traps. Use the following StoreOnce CLI
command (note that snmp v1 and v2 use different parameters to SNMP v3).
snmp add trapsink
2. Add SNMP users and set any authentication required. Use the following StoreOnce CLI
command:
snmp add user
3. Send a test event to IRS and other trap recipients to test that SNMP is set up correctly and
that traps are getting to the trapsinks. Use the following StoreOnce CLI command.
snmp send testtrap
NOTE:
the StoreOnce GUI page to test that SNMP is set up correctly and that traps can successfully
make it to the trapsinks.
NOTE: You will need to use the StoreOnce System CLI to perform other advanced operations,
such as to add or delete trap hosts, to add or delete users, or to enable or disable SNMP. The
StoreOnce GUI provides a useful option after configuration for viewing trapsink and user details,
and for viewing events.

StoreOnce GUI

In the Navigator select SNMP from Device Configuration.
During initial configuration, use the top half of the page to modify SNMP Agent details.
NOTE: The bottom half of this page contains SNMP Trapsinks and SNMP Users. These are
both configured on the StoreOnce CLI and cannot be modified from the StoreOnce GUI. For
more information about the information shown on the SNMP Trapsinks and SNMP Users tabs,
see the Online Help or the user guide for your product.

Modify the SNMP Agent Setup

1. In the SNMP Agent Setup pane, click Modify.
34 Setting up SNMP (Simple Network Management Protocol)
Once SNMP has been configured, you can also use the SNMP Test function on