HP StoreOnce 3100 System Installation And Configuration Manual page 46

Table 11 Network Configuration IP protocol and DNS fields (continued)
Field name
Protocol: IPv4 or IPv6
DNS Address 1/2/3
Step 2: Create Port Sets
1. On the Port Set bar click Add to create the first Port Set.
2. Enter a name for the Port Set and select the ports to use. Available ports depend upon the
model of StoreOnce System and whether ports have already been assigned. Only those
ports that are available are active for selection; others are greyed out if they are already in
use.
Some hardware products support optional PCI-E cards for 10 Gbit Ethernet. If your system
has these cards installed, they are included in the Ports section with the network type clearly
indicated.
See Optional PCIe cards (page 60)
Click on the Show Port Picture link to display a picture of the rear of the model with ports
labeled.
46 Complete network configuration
Description
The radio button selected defines the Internet Protocol
for the DNS servers.
Up to three IPv4 and/or IPv6 DNS addresses may be
defined. The format of the address details is as
appropriate for the protocol selected.
In order to use FQDNs "Fully Qualified Domain Names"
rather than an IP address to access the StoreOnce
System, the DNS server addresses that you provide
should be able to resolve addresses for all configured
subnets. If you are using IPv4 and IPv6 addressing, then
DNS servers configured need to be able to resolve both
IPV4 and IPV6 FQDNs. Up to three DNS servers (one
primary, and two backup servers if the primary is
unavailable) may be configured for the StoreOnce System,
which have IPv4 and/or IPv6 addresses.
for more information about optional hardware.