Powering Up And Setting Up Ilo4; Powering Up The Storeonce 5500 System - HP StoreOnce 3100 System Installation And Configuration Manual

3 Powering up and setting up iLO4

If the StoreOnce system has not yet been powered on, as described in the appropriate Start
Here poster, or if you need to configure iLO 4 from a direct connection, perform the following
steps.

Powering up the StoreOnce 5500 System

1. Perform a final check to ensure all cables are connected correctly and securely:
Head server unit
Two power cables to the head server
Keyboard and monitor cables
Network cable to LAN port 1
Network cable to iLO port
Optional hardware — see the StoreOnce Optional Hardware Installation and
Configuration Guide
Disk enclosure(s)
Four power cables to the disk enclosure
Two 2m SAS cables from the disk enclosure to the first RAID controller card (slot 2)
Two 0.5m SAS cables between the drawers on the disk enclosure
NOTE:
2. Power on all installed disk enclosures first. You may need to hold down the power on button
(1) on the rear of each unit for up to 30 seconds. Look at the LEDs on the I/O modules and
wait until the Green Status LED (3) remains on, and the Locate LED (2) and the Fault LED
(4) are both off.
1
3. Power on the HPE StoreOnce 5500 System (the power button is on the front of the unit).
The Power button LED flashes green during the power-on sequence, and the Power button,
System Health and NIC status LEDs all show steady green when the StoreOnce System is
powering up.
16 Powering up and setting up iLO4
See Hardware overview (page 53)
2
3
4
1 2 3
for cabling examples.
4 5 6 7 8
SID