Airflow Direction Control - Vivax ACP-18COFM50AEEI User Manual

Airflow direction control

 Adjust the air flow direction properly otherwise it might cause
discomfort or cause uneven room temperatures.
Adjust the horizontal/vertical louver using the remote

controller. For some models, the vertical louver can only be
adjusted manually.
To set the horizontal/vertical airflow direction
 Perform this function while the unit is in operation.
 Use the remote controller to adjust the air flow direction. The
vertical/horizontal louver changes6 degree in angle for each
press, or swing up and down automatically. Please refer to
the "REMOTE CONTROLLER OPERATION MANUAL
details.
 For some models, the vertical louver can only be adjusted
manually. Move the deflector rod manually to adjust the air
flow in the direction you prefer.
IMPORTANT: Do not put your fingers into the panel of blower
and suction side. The high-speed fan inside may cause
danger.
• Do not operate the air conditioner for long periods with the
air flow direction set downward in cooling or dehumidifying
mode. Otherwise, condensation may occur on the surface of
the horizontal louver causing moisture to drop on to the floor
or on furnishings.
• Do not move the horizontal louver manually unless it is
necessary. Always use the remote controller.
• When the air conditioner is started immediately after it was
stopped, the horizontal
approximately 10 seconds.
• Open angle of the horizontal louver should not be set too
small, as COOLING or HEATING performance may be
impaired due to too restricted air flow area.
• Do not operate unit with horizontal louver in closed position.
• When the air conditioner is connected to power (initial
power), the horizontal louver may generate a sound for 10
seconds, this is a normal operation.
13
CAUTION
louver might not move for
,
for