Operating Instructions; Airflow Direction Control - Vivax ACP-09CH25AEM User Manual

OPERATING INSTRUCTIONS

Airflow direction control

SET TEMPERATURE
AUTO
COOL
DRY
HEAT
TEMP
ON/OFF
MODE
SWING SLEEP
RESET LOCK
AIR
DIRECTION
Range
Range
Adjust the air flow direction properly otherwise, it might
cause discomfort or cause uneven room temperatures.
Adjust the horizontal louver using the remote controller.
¡£
( C)
Adjust the vertical louver manually.
FAN
HIGH
MED
LOW To set the vertical air flow(Up--Down) direction
Perform this function while the unit is in operation.
Keep pressing the AIR DIRECTION button on the
remote controller to move the louver to the desired
FAN SPEED
direction. The readjusting angle of the horizontal
louver is 6 for each press.
TIMER ON
TIMER OFF
To set the horizontal air flow direction (left - right)
Adjust the vertical louver manually using the lever on the
LED
DISPLAY TURBO
left or right side of the vertical louver arm (Depending on
model). Take care not to catch fingers on the fan, horizontal
louver or to damage vertical louvers. When the air
conditioner is in operational and the horizontal louver is in
a specific position, move the lever at left (or right, depending
on model) end of the air outlet to the desired position.
To automatically swing the air flow direction (up - down)
Perform this function while the air conditioner is in operation.
Keep pressing the AIR DIRECTION button without releasing
for more than 2 seconds or press the SWING button on the
remote controller, the horizontal louver will swing up and
down automatically.
To stop the function, press the SWING button again.
CAUTION
!
The SWING and AIR DIRECITON button will be disabled when the air
conditioner is not in operation(including when the TIMER ON is set).
Do not operate the air conditioner for long periods with the air flow
direction set downward in cooling or dry mode. Otherwise,
condensation may occur on the surface of the horizontal
louver causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the SWING
or AIR DIRECTION button. If you move this louver manually, it may
malfunction during operation. If the louver malfunctions, stop the air
conditioner once and restart it.
When the air conditioner is started immediately after it was stopped,
the horizontal louver might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as
COOLING or HEATING performance may be impaired due to too
restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the
horizontal louver may generate a sound for 10 seconds, this is a
normal operation.
7