Decorative Front Dimensions For Finishing - Majestic DBDV36IN Installation Manual

C. Decorative Front Dimensions for Finish-
ing
WARNING! Risk of Burns! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
Only decorative fronts certifi ed for use with this appli-
ance model may be used. Contact your dealer for a list of
decorative fronts that may be used. Once you have deter-
mined what kind of decorative front and fi nishing material
is going to be used on the fi replace, you may use the
table below which shows the models and the fi nishing
material thickness allowed.
DECORATIVE
FIT
FRONT
DBM36BK
Inside
DBM42BK
Overlap
CRD36
CRD42
Inside
Note: Finishing strips may be used to aid in positioning of non-
combustible facing materials for some of the facing and deco-
rative front combinations specifi ed in the table above. They
must be removed following fi nishing work. See Figure 10.7.
Majestic • DBDV36IN, DBDV36IL, DBDV42IN, DBDV42IL Installation Manual • 2397-980 Rev. B • 5/16
FINISH MATERIAL SEE
THICKNESS FIGURE
Any 10.8
1 inch or less 10.6
1-4 inches 10.7
CRD36, CRD42
Overlap Fit (0-1 Inch Thick Finishing Method)
Non-Combustible Finish Materials
Remove Finishing Strips. See Figure 10.9.
NOTICE: Remove fi nishing strips before fi ring appliance.
WARNING! Risk of Fire! DO NOT apply fi nishing mate-
rial beyond the fi nishing strips. Appliance will overheat if
fi nishing material extends into appliance opening.
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
FINISHING STRIP NOT USED
removal instructions)
Figure 10.6 Overlap Fit Decorative Front - Finish Material 0-1
Inch Thick
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
(See Figure 10.9 for
NON-COMBUSTIBLE
FINISHING MATERIAL
1 IN. MAX.
51