Majestic DBDV36IN Installation Manual page 60

LOG INSTALLATION:
Note: Logs are placed in appliance in alphabetical order.
1. (LOG A): Locate the two pin holes on the bottom of
Log A. Hold the log so that the fl at spot is facing the rear
of the appliance and the pin holes are facing the base
pan. Place Log A over the two pins referenced for Log A
in Figure 4. Refer to Figure 5.
A A
Figure 5. Log A Installed
2. (LOG B): Locate the pin hole on the bottom of Log B.
Place pin hole on Log B over the pin referenced for Log B in
Figure 4. Hold the log over the pin and rotate the left side
of the log until it contacts the left grate tine. See Figure 6.
B B
LOG CONTACTS LOG CONTACTS
LEFT GRATE TINE LEFT GRATE TINE
Figure 6. Log B Installed
Majestic • DBDV36IN, DBDV36IL, DBDV42IN, DBDV42IL Installation Manual • 2397-980 Rev. B • 5/16
60
A A
3. (LOG C): Locate the notch on Log C. Place the
notch over the center grate tine, and rear of log between
the right grate tine and Log Pin C as shown in Figure 7.
Move notched end of log forward until it stops, then rotate
rear of log to rear until it contacts Log Pin C.
NOTCH FOR LOG D NOTCH FOR LOG D
A A
B B
NOTCH NOTCH
FLAT SPOT FOR LOG D FLAT SPOT FOR LOG D
Figure 7. Log C Installed
4. (LOG D): Log D will utilize two fl at spots for its placement
as shown in Figure 7. The fl at spots are located on Log
A and on Log C. Locate the end of Log D that does not
have bark and place it into the notch on Log A. Place the
other end of Log D on the fl at spot on Log C. See Figure
8. The front edge of Log A may lift off the burner/hearth
pan slightly when Log D is placed properly.
A A
B B
Figure 8. Log D Installed
LOG C CONTACTS LOG C CONTACTS
LOG PIN C AT REAR LOG PIN C AT REAR
FLAT SPOTS FLAT SPOTS
FOR LOG E FOR LOG E
C C
D D
C C