Majestic DBDV36IN Installation Manual page 36

Figure 6.6 (Generic Fireplace Shown) To attach the fi rst
section of vent pipe, make sure to use the fi berglass gasket
in the manual bag to seal between the fi rst vent component
and the outer fi replace wrap. Use 2 self tapping screws to
secure the gasket to the outer wrap.
Secure the fi rst section of venting to the fi replace by screw-
ing through the two straps left over from cutting the seal
cap strap in step 2.
Rear Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
Figure 6.7 (Generic Fireplace Shown) Cut the metal re-
taining band and fold the sides out.
Majestic • DBDV36IN, DBDV36IL, DBDV42IN, DBDV42IL Installation Manual • 2397-980 Rev. B • 5/16
36
Figure 6.8 (Generic Fireplace Shown) Fold the center
parts of the retaining band out and use to remove the seal
cap.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure 6.9 (Generic Fireplace Shown) Discard the vent
cap, remove and discard the insulation basket.