Majestic DBDV36IN Installation Manual page 61

5. (LOG E1): Log E will utilize two fl at spots for its
placement as shown in Figure 7. The fl at spots are located
on Log A and on Log C. Place the "bark" end of Log E1
on the fl at spot on Log A. Rest the other end of Log E on
the fl at spot of Log C. The back of Log E1 should be fl ush
with the back of Log A. See Figure 9.
LOGS A & E1 FLUSH AT BACK OF FIREBOX LOGS A & E1 FLUSH AT BACK OF FIREBOX
A A
D D
B B
C C
Figure 9. Log E Installed
6. (LOG F): Place Log F into appliance as shown in Figure
10. The burned out end of the log should rest on Log C
and contact Log E1. The unburned end of Log F should
rest against log pin F, as shown in Figure 4, and contact
the back of the lower grate tine as noted in Figure 10.
A A
E1 E1
C C
LOG F RESTS AGAINST LOG F RESTS AGAINST
PIN AND CONTACTS GRATE PIN AND CONTACTS GRATE
Figure 10. Log E Installed
Majestic • DBDV36IN, DBDV36IL, DBDV42IN, DBDV42IL Installation Manual • 2397-980 Rev. B • 5/16
E1 E1
F F
7. (LOG E2): Place Log E2 into appliance as shown in
Figure 11. The base of the log should be positioned against
the pin indicated in Figure 4 for Log E2. The top side
should rest against Log A. The base end of Log E2 should
be approximately one inch from the left side of the fi rebox.
1 IN.GAP 1 IN.GAP
Figure 11. Log E2 Installed
8. (LOG E3): Place Log E3 into appliance as shown in
Figure 12. The bark should be toward the front of the
appliance. The bottom of the log should be fl at against
the surface of Log F as shown in Figure 13. Slide Log E3
toward the rear of the fi rebox until it contacts the log pin,
keeping the fl at surfaces in contact as noted in Figure 13.
Log E3 should contact Log C as noted in Figure 12. Figure
3 shows the installed log set.
LOG E3 CONTACTS LOG C LOG E3 CONTACTS LOG C
A A
C C
E1 E1
F F
Figure 12. Log E3 Installed
A A C C
E1 E1 F F
SURFACE MUST BE FLAT SURFACE MUST BE FLAT
Figure 13. Log E3 Installed
E2 E2 A A D D
B B
E3 E3
E3 E3
2397-935B
61