Appliance Setup; Fixed Glass Assembly; Remove The Shipping Materials/Inspect Grate - Majestic DBDV36IN Installation Manual

11 11

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass assembly from the
appliance. See Figure 11.1.
Replacing Fixed Glass Assembly
• Replace the glass assembly on the appliance. Pull out
and latch the four glass assembly latches into the groove
on the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 11.1 Fixed Glass Assembly
Majestic • DBDV36IN, DBDV36IL, DBDV42IN, DBDV42IL Installation Manual • 2397-980 Rev. B • 5/16
54
B. Remove the Shipping Materials/Inspect
Grate
Remove shipping materials from inside or underneath
the fi rebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before fi nishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the appliance,
depending on the fi replace model. Splatter guards
must be removed before appliance is fi red.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
• Inspect the grate prior to installing the embers, logs
and lava rock. The grate tine on the right hand side
should be parallel to the burner. See Figure 11.2. If
the grate is not parallel to the burner, contact your
dealer.
GRATE TINE PARALLEL WITH BURNER GRATE TINE PARALLEL WITH BURNER
Figure 11.2 Grate Tine Parallel to Burner
(Appliance Shown with Optional Refractory Installed)