Allen-Bradley PowerFlex 700S Quick Start Manual page 33

PowerFlex 700S
Esc
Start-Up
Motor Control Motor Data
Select Motor Control
Enter Motor NP Data
Mode
Power & Units
Select DB Resistor
Motor Tests Inertia Measure
Measure System
Field Oriented
Control: Measure
Stator Resistance,
Leakage Inductance,
Magnetizing
Inductance
PMag Motor: Encoder
Offset, Stator
Resistance, Stator
Inductance, Back EMF
Down 1 level or Select
Back 1 level or 1 selection
Scroll all choices
Feedback
Configuration
Setup / Select
Encoder
Resolver
FLA
Hi-Res Encoder
Volts
Linear Sensor
Hertz
RPM
Poles
Speed Limits
Select Direction
Control
Inertia
Set FWD, REV and
ABS Speed Limits
(1)
See "Important" statement about the HIM on
Note: In 2-wire mode, the drive will start when the HIM "Start" is pressed
and stop when the HIM "Start" is released. The recommended mode of use
for the Start-Up Routine is 3-wire control, Parameter 153 [Control Options],
Bit 8 set to "1".
Power Circuit Test Direction Test
Diagnostic Check for
Verify Direction
Drive Power Circuit
Speed Control Start / Stop / I/O
Select Sources For All Configure:
Digital Inputs, Digital
Speed References
Outputs, Analog
Inputs, Analog Outputs
page 32
33
(1)
Done /
Exit