Applying Power To The Drive - Allen-Bradley PowerFlex 700S Quick Start Manual

30
DRIVE DRIVE
4
ENABLE
SYNCHLINK

Applying Power to the Drive

The remainder of this procedure requires that a Human Interface Module
(HIM) be installed. If an operator interface is not available, remote devices
should be used to start-up the drive.
PWR (Power)
1
2
STS (Status)
3
❏ 6. Apply AC power and control voltages to the drive. Examine the Power
(PWR) LED.
Table N Drive Status Indicator Descriptions
# Name Color State
➊
PWR Green Steady
(Power)
➋
STS Green Flashing
(Status)
Steady
Yellow Flashing
Steady
Red Flashing
Steady
Red / Flashing
Yellow Alternately
➌
PORT
Refer to the
MOD
Communication
NET A
Adapter User Manual
NET B
➍
SYNCHLINK Green Steady
Green Flashing
Red Flashing
ENABLE Green On
Green Off
Description
Illuminates when power is applied to the drive.
Drive ready, but not running & no faults are present.
Drive running, no faults are present.
When running, a type 2 (non-configurable) alarm condition exists,
drive continues to run. When stopped, a start inhibit exists and the
drive cannot be started.
A type 1 (user configurable) alarm condition exists, but drive
continues to run.
A fault has occurred.
A non-resettable fault has occurred.
The drive is in flash recovery mode. The only operation permitted is
flash upgrade.
Status of DPI port internal communications (if present).
Status of communications module (when installed).
Status of network (if connected).
Status of secondary network (if connected).
• The module is configured as the time keeper.
or
• The module is configured as a follower and synchronization is
complete.
The follower(s) are not synchronized with the time keeper.
The module is configured as a time master on SynchLink and has
received time information from another time master on SynchLink.
The drive's enable input is high.
The drive's enable input is low.
➊
➋
➌