Chapter 6 Disassembly and Repair
Mechanical Disassembly
Mechanical Disassembly
For procedures in this manual, the following tools are required for
disassembly:
• T20 Torx driver (most disassembly)
• T15 Torx driver (support plate and fan removal)
9
•
/
-inch or adjustable open-end wrench (rear-panel BNC connectors)
16
The following tools may also be needed if further disassembly is
required.
• 7 mm nut driver (rear-panel GPIB connector)
WARNING
SHOCK HAZARD. Only service-trained personnel who are aware
of the hazards involved should remove the instrument covers.
To avoid electrical shock and personal injury, make sure to disconnect
the power cord from the instrument before removing the covers. Some
circuits are active and have power applied even when the power switch is
turned off.
6
112