Installation Instructions - Danfoss TRONE-RF Installation Manual

Installation Instructions

Specifications
Operating Voltage
Output relay
Setting temperature range
Operating temprature range
Switch rating
Switch type
Battery lifetime
IP rating
On/off control
Chrono-proportional control
Operating mode
Construction
Control pollution situation
Rated impulse voltage
Ball pressure test
Dimensions (mm)
Software Classification
Important note RF products: Ensure that there are no large metal objects,
such as boiler cases or other large appliances, in line of sight between the
transmitter and receiver as these will prevent communication between
thermostat and receiver.
ErP Class
The products represented within this document are classified according
to, and allow completion of, the Energy Related Product (ErP) Directive
System Package fiche and the ErP system data label. ErP Labelling
obligation is applicable from 26th September 2015.
ERP Class Product Function and ErP Description
TPI Room Thermostat, for use with on/off
ErP
IV output heaters
An electronic room thermostat that controls
4
Product
both thermostat cycle rate and in-cycle on/
Class
off ratio of the heater proportional to room
temperature. TPI control strategy reduces
mean water temperature, improves room
temperature control accuracy and enhances
system efficiency.
Danfoss Heating
TPOne-RF
2.5 - 3VDC
(2x AA batteries)
-
5-35°C
0-45°C
-
-
Min. 2 years
IP20
Yes
Yes
Heating
EN 60730-2-9
Degree 2
-
H67 x W154 x D30
RX1-S
230Vac, 50/60Hz
Volt Free
-
3A (1) at 230Vac
1 x SPDT Type 1B
IP40
-
-
-
EN 60730-1
2.5kV
75°C
H84 x W84 x D28
A
Additional
efficiency
gain
2%
3