Danfoss TRONE-RF Installation Manual page 26

Warnings (continued)
Service Due
Heat
Reduced
High Floor
Temperature
Sensor Fail
External
Sensor Fail
Floor
Sensor Fail
26
Where the TPOne Service Interval timer has been
set this warning will be shown when the timer has
expired. Contact the property owner or landlord
to arrange the boiler safety mainantance.
see page 21
Where the TPOne Service Interval timer has been
set this warning will show after the timer has
expired and will indicate that heating has been
reduced for your safety until a boiler service has
been completed. Contact the property owner or
landlord to arrange the boiler safety mainantance.
see page 21
Where a floor limit temperature sensor has been
fitted if the floor temperature exceeds the set limit
this warning will show. If the floor temperature
has reduced to a safe level the TPOne will continue
to control heating but the reason for the overheat
may still exist. The floor heating system should be
checked to ensure overheating does not reoccur.
If the TPOne in-built temperature sensor is
measuring outside it's operational parameters
then it may have failed. If this warning cannot be
reset then contact your service provider for advice.
If an external temperature sensor has been
fitted and the TPOne is measuring outside it's
operational parameters then it may indicate a
problem with the external sensor or connecting
cable. If this warning cannot be reset then contact
your service provider for advice.
If a floor temperature sensor has been fitted and
the TPOne is measuring outside it's operational
parameters then it may indicate a problem with
the floor sensor or connecting cable. If this
warning cannot be reset then contact your service
provider for advice.
TPOne-RF