Simrad GO XSE Installation Manual page 64

64
Importing a database
Later, if the unit has been restored to factory defaults or user data is
accidentally deleted, return to the files page, select the backed up
file, and then Import. View file details for creation date.
Software upgrades
The update file must be loaded to the root directory of the memory
card.
The update may be initiated at boot up: insert the memory card into
the card reader before turning the unit on, boot the unit, and follow
the on-screen instructions.
Alternatively, in the Files menu, locate the update file on the
memory card inserted in the card reader and select Upgrade,
followed by This Display. Accept the prompt to reboot the unit,
and wait a few moments as the unit restarts. Do not remove the
memory card or repower the unit until the process is completed
(this typically takes no more than a couple of minutes).
Software upgrade of remote device
It is possible to run an update remotely from one unit and apply it
to another, provided they are on the NMEA network. This is only
possible for units without a card slot.
Remote updating is similar to updating a local unit; select the file on
the memory card and select the Upgrade option, followed by
Remote Upgrade. Follow the onscreen options.
NMEA 2000 device upgrades
The update file must be loaded to the root directory of a memory
card inserted in the card reader.
1.
Select the Files toolbar option and select the update file under
Memory card.
2.
Select the Upgrade option presented when the file is
highlighted. A list should appear displaying any compatible
devices the update file applies to. In most cases this will be a
single device.
Ú Note:
If no device is shown, check that the device to be
updated has power, and run any outstanding updates for the
unit first.
Software Setup | GO XSE Installation Manual