Simrad GO XSE Installation Manual page 58

58
assigned in the Device Name setting. If the unit does not
appear, follow the on screen instructions to manually find the
device.
5.
Select the graphic icon of the unit. The unit displays a prompt
similar to the following:
6. Select Yes for one-time connection, or Always if device is to be
remembered for regular connection. This setting can be
changed later if required.
Ú Note:
The internal wireless module only supports GoFree
connection to itself. Other units connected on the network are
not visible.
Connecting a smartphone
Install the GoFree App on the smartphone before following this
procedure.
1.
Navigate to the wireless network connection page on the
smartphone, and find the unit or GoFree wireless xxxx network. If
more than one is in range, review the Wireless devices page
from the unit's Wireless settings dialog to confirm which
wireless device is connected to the unit.
2. Select a device on the Wireless devices page to show its
Network Key.
3.
Enter the Network Key in the smartphone to connect to the
network.
4.
Open the GoFree application on the smartphone, the unit
should be automatically detected. The name displayed will be
either the default, or that assigned in the Device Name setting. If
the unit does not appear, follow the on screen instructions to
manually find the device.
The MFD's display is shown on the smartphone. To change the
MFD's display on the smartphone, use the MFD to change the
display on the MFD. The display change on the MFD is reflected on
the smartphone.
Software Setup | GO XSE Installation Manual