Table of Contents
Advertisement
CAUTION:
check the full lifting range of the snowblower,
to ensure that the chute rotation handle is
clear of the operator's area when the
snowblower is in raised position.
14. Install plastic handle (fig.4 item 9) over
rotation handle.
15. Tighten all bolts according to the Torque
Specification Table at the end of the manual.
NOTE:
To
convert
DEFLECTOR, replace the adjustment rod and
tube with a 2" x 6" cylinder.
Snowblower Installation
1. Attach tractor lower hitch arms (fig.5, items 1)
to snowblower attaching plates using the hitch
pins and secure with linchpins (fig.5, items 2).
2. Install the tractor upper hitch (fig.5 item 3) on
the upper hole of snowblower (fig.5, item 5)
attaching plates using tractors pins and
linchpins (fig.5, items 4).
3. Adjust snowblower using the tractor upper
hitch so that it runs level.
4. Set the tractor anti-sway turnbuckles so the
snowblower does not sway.
OM 0279-A
ASSEMBLY
To avoid personal injury,
to
a
HYDRAULIC
Figure 5
CAUTION:
snowblower driveline to tractor drive shaft,
make sure driveline is not too long in raised,
lowered and middle position. If the driveline
is too long it must be shortened, to avoid
damaged to tractor.
5. Connect driveline to tractor drive P.T.O.,
make sure that the driveline yoke pin is
properly engaged.
Removing Snowblower from Tractor
1. Set snowblower completely on the ground to
release all pressure from the three-point. Set
parking brake and turn engine off.
2. Detach upper link by removing linchpin and
pin (fig.5, items 4).
3. Disconnect driveline from tractor P.T.O. shaft
and set driveline on support chain.
4. Carefully detach lower links (fig. 5, items 1)
by removing linchpins (fig.5, items 2) and
loosen anti-sway turnbuckles.
IMPORTANT:
To
snowblower, retorque all bolts after the first
10 hours of operation.
12
Before connecting
avoid
damage
to
:
the
Hide quick links:
Advertisement
Table of Contents
