Maintenance; Storage; Driveline; Lubrication - Blizzard B54 Operator And Parts Manual

M
AINTENANCE

Storage

1. Check the shear bolts at frequent intervals for
proper tightness to be sure the blower is in
safe working condition.
2. Never store the tractor with fuel in the fuel
tank inside a building where open flame or
sparks are present. Allow the engine to cool
before storing in any enclosure.
3. Run the snowblower a few minutes after
blowing snow to prevent freeze up of the
auger and the impeller.
WARNING: Provide adequate blocking
before working under the snowblower when in the
raised position.

Driveline

IMPORTANT: When the snowblower is not
used for more than two weeks, perform
driveline maintenance and always store it in a
dry place, away from bad weather conditions.
OM 0279-A

MAINTENANCE

Lubrication

1. GEAR : Check the oil level in the worm gear
2. REDUCTION CHAIN : Lubricate with chain
3. DRIVELINE (S) : Grease each u-joint fitting
4. ROTATION SHAFT : Grease the shaft each 8
16
drive every month. If necessary add SAE
80W90 gear oil, AGMA 5EP or equivalent.
saw lubricant every 4 hours of operation and
after each use.
every 8 hours of operation. Slide drive shaft
apart and coat sliding surfaces with grease
every 8 hours of operation.
hours of operation.