Blizzard B54 Operator And Parts Manual page 13

5. Install the adjustment tube (fig. 2, item 3) in
the lower hole on the backside of the chute
and the adjustment rod (fig. 2, item 2) in the
upper hole. Lock in place using the 1/4" x 2"
(fig. 2, item 7) cotter pins then insert the
∅5mm x 100mm hair pin (fig. 2, item 6) in the
adjustment tube hole (fig. 2, item 3)
6. Install the chute (fig.2, item 1) over the plastic
insert (fig.2, item 4), applying grease in
between, and place the four retaining plates
(fig.2, item 5). Secure using eight 1/4'' x 3/4''
bolts, lockwashers and nuts (fig.2, items 8-9-
10). Tighten all bolts securely.
7. Install the support angle (fig 4, item 21) on the
3 point left attaching plate using two 3/8''NC x
1 1/4'' bolts, lockwashers and nuts (fig. 4,
items 16-17-18). Tighten securely.
8. Install anchor tube (fig.4, item 15) on the
support angle (fig.4, item 21) using a 3/4''NC x
1 1/2'' bolt, lockwasher and nut (fig. 4, items
22-23-24) making sure the tube leans toward
the tractor.
Figure 4
OM 0279-A
ASSEMBLY
9. Insert handle bracket (fig.4, item 14) inside
anchor tube (fig.4, item 15). Adjust the height
of the handle bracket according to your needs
and shorten it if necessary. Fasten loosely with
a 3/8'' x 5/16'' set screw (fig 4, item 19).
10. Insert assembled rotation tube (fig.4, item 2)
inside the rotation worm.
insert a 10-24 x 1'' capscrew (fig.4, item 12)
making sure the capscrew sinks in the worm.
Secure with a nylon lock nut (fig. 4, item 13).
11. Install the plastic grommet (fig.4, item 20) in
the handle support.
12. Insert the handle (fig.4, item 1) inside the
grommet and inside the rotation tube (fig.4,
item 2) . Select desired length, align nearest
holes and secure with a 5mm x 100mm
hairpin (fig. 4, item 8).
13. Adjust handle position and height to a
comfortable and safe operating position after
the snowblower has been mounted to the
tractor. Tighten setscrew (fig 4, item 19) on
anchor tube and the 3/4'' x 1 1/2'' bolt
securely (fig. 4, item 22).
11
Align holes and