Applying The Address Pool To An Interface - HP A5120 EI Series Configuration Manual

To do...
Create a DHCPv6 address pool
and enter DHCPv6 address pool
view
Configure a static prefix
Apply a prefix pool to the
address pool
Configure a DNS server address
Configure a domain name
Configure the IPv6 address or
domain name of a SIP server
NOTE:

Only one prefix pool can be referenced by an address pool.

A non-existing prefix pool can be referenced by an address pool. However, no prefix is available in the prefix
pool for dynamic prefix assignment until the prefix pool is created.

You cannot modify the prefix pool referenced by an address pool, or the preferred lifetime or valid lifetime by
using the prefix-pool command. You need to remove the configuration before you can have another prefix pool
referenced by the address pool, or modify the preferred lifetime and valid lifetime.

You can configure up to eight DNS server addresses, one domain name, eight SIP server addresses, and eight
SIP server domain names in an address pool.

Applying the address pool to an interface

After an address pool is applied to an interface, a prefix and other configuration parameters can be
selected from the address pool and assigned to the DHCPv6 client requesting through the interface.
Follow these steps to apply an address pool to an interface:
To do...
Enter system view
Enter interface view
Apply the DHCPv6 address pool
to the interface
Use the command...
ipv6 dhcp pool pool-number
static-bind prefix prefix/prefix-len duid
duid [ iaid iaid ] [ preferred-lifetime
preferred-lifetime valid-lifetime valid-
lifetime ]
prefix-pool prefix-pool-number [
preferred-lifetime preferred-lifetime valid-
lifetime valid-lifetime ]
dns-server ipv6-address
domain-name domain-name
sip-server { address ipv6-address |
domain-name domain-name }
Use the command...
system-view
interface interface-type interface-number
ipv6 dhcp server apply pool pool-number
[ allow-hint | preference preference-value
| rapid-commit ] *
149
Remarks
Required
Not configured by default.
Required
Use either command.
No prefix is specified by
default.
Optional
Not configured by default.
Optional
Not configured by default.
Optional
Not configured by default.
Remarks
—
—
Required
Not configured by default.