HP A5120 EI Series Configuration Manual page 101

Figure 43 Network diagram of dynamic domain name resolution
2::2/64
DNS server
Configuration procedure
NOTE:

Before performing the following configuration, make sure that the device and the host are accessible to each
other via available routes, and the IPv6 addresses of the interfaces are configured as shown

This configuration may vary with different DNS servers. The following configuration is performed on a PC
running Windows Server 2003. Make sure that the DNS server supports the IPv6 DNS function so that the server
can process IPv6 DNS packets, and the interfaces of the DNS server can forward IPv6 packets.
Configure the DNS server
1.
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
instructions to create a new zone named com.
Figure 44 Create a zone
# Create a mapping between the host name and the IPv6 address.
As shown in
2::1/64 3::1/64
Device
DNS client
Figure 44, right click Forward Lookup Zones, select New zone, and then follow the
Figure 45, right click zone com.
IP network
1::1/64
host.com
Host
93
Figure 43.