HP A5120 EI Series Configuration Manual page 145

# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Configure a global unicast address for VLAN-interface 2.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
[SwitchB-Vlan-interface2] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address 3001::1.
[SwitchB] ipv6 route-static 2001:: 64 3001::1
Configure Host
3.
# Enable IPv6 for Host to automatically obtain an IPv6 address through IPv6 ND.
# Display the neighbor information of GigabitEthernet 1/0/2 on Switch A.
[SwitchA] display ipv6 neighbors interface GigabitEthernet 1/0/2
IPv6 Address
FE80::215:E9FF:FEA6:7D14
2001::15B:E0EA:3524:E791
The information
2001::15B:E0EA:3524:E791.
Verification
# Display the IPv6 interface settings on Switch A. All the IPv6 global unicast addresses configured on the
interface are displayed.
[SwitchA] display ipv6 interface vlan-interface 2 verbose
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::20F:E2FF:FE00:2
Global unicast address(es):
3001::1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FF00:2
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives:
InTooShorts:
InTruncatedPkts:
InHopLimitExceeds:
InBadHeaders:
Type: S-Static D-Dynamic
Link-layer
0015-e9a6-7d14
0015-e9a6-7d14
shows that the IPv6
25829
0
0
0
0
VID Interface
1 GE1/0/2
1 GE1/0/2
global unicast address
137
State T Age
STALE D 1238
STALE D 1248
that Host obtained is