Configuration Tables; Configurations With Engineering Station, Clients And Single Station System - Siemens PCS 7 Installation Manual

Appendices
6.2 Appendix B - Approved configurations on a PC station
Notes for the reader on the tables below
Note
Read Tables 1 - 3 carefully from left to right. This means that a PC with a standard installation
can also be used for an additional purpose (by using properties or an additional installation by
means of the PCS 7 system setup).
Example:
If you also use a PC station with the standard configuration "engineering station" as an "OS
single station system", the notes and restrictions defined under "A" (configuration type "A") will
apply.
Notes and restrictions:
You can find information on this in the following sections:
● Section "Information on configuration type "X" (Page 148)"
● Section "Information on configuration type "-" (Page 149)"
● Section "Information on configuration type "A" (Page 149)"
● Section "Information on configuration type "B" (Page 149)"
6.2.2

Configuration tables

6.2.2.1

Configurations with engineering station, clients and single station system

Table 1 – Configurations with Engineering Station, Clients and Single Station System
Purpose Engineering
station
Standard config‐
uration
Engineering sta‐
tion
OS --- (Page 149)
single-station
system
OS client --- (Page 149) --- (Page 149)
BATCH single --- (Page 149) X (Page 148)
station system
BATCH Client --- (Page 149) --- (Page 149)
146
OS OS
single-station client
system
A (Page 149) B
(Page
149)
---
(Page
149)
X
(Page
148)
X
(Page
148)
BATCH single BATCH
station system client
--- (Page 149) X
(Page
148)
X (Page 148) X
(Page
148)
X (Page 148) X
(Page
148)
---
(Page
149)
--- (Page 149)
Installation Manual, 03/2016, A5E36200050-AB
Route Control Route
single station Control
system Client
--- (Page 149) X
(Page
148)
X (Page 148) X
(Page
148)
X (Page 148) X
(Page
148)
X (Page 148) ---
(Page
149)
--- (Page 149) X
(Page
148)
PCS 7 - PC Configuration (V8.2)