Table of Contents
Advertisement
Object
Fragment Threshold
RTS Threshold
Beacon Interval
IAPP
Protection
Aggregation
Short GI
WLAN Partition
STBC
LDPC
User Manual of WDAP-C7200AC/WDAP-W7200AC
You can specify the maximum size of packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in
bad performance.
Default is "2346".
When the packet size is smaller than the RTS threshold, the access
point will not use the RTS/CTS mechanism to send this packet.
Default is "2347".
The interval of time that this access point broadcasts a beacon.
Beacon is used to synchronize the wireless network. Default is "100".
IAPP (Inter-Access Point Protocol) enabled is recommended as it
describes an optional extension to IEEE 802.11 that provides wireless
access-point communications among multi-vendor systems.
Default is "Enabled".
It is recommended to enable the protection mechanism. This
mechanism can decrease the rate of data collision between 802.11b
and 802.11g wireless stations. When the protection mode is enabled,
the throughput of the AP will be a little lower due to the transmission of
heavy frame traffic.
Default is "Disabled".
It is a function where the values of multiple rows are grouped together.
Default is "Enabled"
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is "Enabled"
This feature is also called "WLAN isolation" or "Block Relay". If this is
enabled, wireless clients cannot exchange data through the
WDAP-C7200AC/WDAP-W7200AC.
Default is "Disabled".
Activate Space Time Blocking Code (STBC) which does not need
channel statement information (CSI).
Default Setting: "Enabled"
Low-density Parity-check Code is wireless data transmit algorithm.
Default Setting: "Enabled"
-53-
Description
Advertisement
Table of Contents
