Table of Contents
Advertisement
The page includes the following fields:
Object
Standalone AP
Managed AP
AP Controller IP Address
Apply Change
Reset
After you configure the settings on the AP Operation Mode page, you must click Apply
to apply the changes and to save the settings. Changing some settings might cause the
AP to stop and restart system processes. If this happens, wireless clients will
temporarily lose connectivity. We recommend that you change AP settings when WLAN
traffic is low.
Please back up the configuration settings before switching from the Standalone AP
mode to the Managed AP mode.
All the configurations will be erased and at the same time, the system will return to the
factory default settings once it is reverted to the Standalone AP mode.
User Manual of WDAP-C7200AC/WDAP-W7200AC
Figure 5-2 Operation Mode
Description
In Standalone AP, the AP acts as an individual AP in the network, and you
manage it by using the Administrator Web User Interface (UI), or SNMP.
In Managed AP, the AP is part of the PLANET Wireless AP controller System, and
you manage it by using the WAPC Wireless AP controller.
Check this option and enter the IP address of the AP controller that user
specifies. The default "0.0.0.0" means any AP controller existed in the local
network can control this AP.
Click "Apply Change" to save and apply the settings.
Click "Reset" to erase all settings.
-26-
Advertisement
Table of Contents
