Table of Contents
Advertisement
Subnet Mask
Default Gateway
DHCP
DHCP Client Range
Static DHCP
Domain Name
802.1d Spanning Tree
Clone MAC Address
UPnP Enable
If you change the IP address of LAN, you must use the new IP address to login the
AP.
When the IP address of the WDAP-C7200AC/WDAP-W7200AC is changed, the
clients on the network often need to wait for a while or even reboot before they can
access the new IP address. For an immediate access to the AP, please flush the
netbios cache on the client computer by running the "nbtstat –r" command before
using the device name of the WDAP-C7200AC/WDAP-W7200AC to access its
Web Management page.
User Manual of WDAP-C7200AC/WDAP-W7200AC
Default is 255.255.255.0. You can change it according to your request.
Default is 192.168.1.253. You can change it according to your request.
You can select a Disabled, Client, and Server. Default is Disabled,
meaning the WDAP-C7200AC/WDAP-W7200AC must connect to a
router to assign IP addresses to clients.
For the Server mode, you must enter the DHCP client IP address
range in the field. And you can click "Show Client" to show the Active
DHCP Client Table.
Click "Set Static DHCP" and you can reserve some IP addresses for
those network devices with the specified MAC addresses anytime
when they request IP addresses.
Default is Planet.
You can enable or disable the Spanning Tree function.
You can input an MAC address here for using clone function.
You can enable or disable the UPnP function. The UPnP feature allows
the devices, such as Internet computers, to access the local host
resources or devices as needed. UPnP devices can be automatically
discovered by the UPnP service application on the LAN.
-35-
Advertisement
Table of Contents
