Setting The Speaker Impedance - Yamaha RX-A3060 Owner's Manual

Notes on installation of ceiling speakers
When installing presence speakers to a ceiling, use the following illustration as a reference.
When using two presence speakers
FPR SR
FR
SBR
C
SBL
FL
FPL SL
Installation position
Just above the listening position, or the
ceiling between extensions of front
speakers and listening position
Caution
Be sure to use speakers that are made for ceiling use and take anti-drop measures. Ask a qualified
contractor or dealer personnel for installation works.
When using four presence speakers
FPR RPR SR
FR
SBR
C
SBL
FL
FPL RPL SL
Installation position
Front presence speakers:
the ceiling between the extensions of the
front speakers and listening position
Rear presence speakers:
the ceiling between the extensions of the
listening position and surround (or
surround back) speakers
⬛

Setting the speaker impedance

Under its default settings, the unit is configured for 8-ohm speakers. When using a 6-ohm
speaker for any channel, set the speaker impedance to "6 Ω MIN". In this case, you can also use
4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall outlet.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
STRAIGHT
3
Check that "SPEAKER IMP." is displayed on the front display.
SPEAKER IMP.
4
Press STRAIGHT to select "6 Ω MIN".
5
Press MAIN ZONE z to set the unit to standby mode and remove the power
cable from the AC wall outlet.
You are now ready to connect the speakers.
27
En
8¬MIN