Error Indications On The Front Display - Yamaha RX-A3060 Owner's Manual

Error indications on the front display

Message
Access denied Access to the PC is denied.
The unit cannot access the USB device.
Access error
There is a problem with the signal path from the network to the unit.
Check SP Wires The speaker cables short circuit.
Internal Error An internal error has occurred.
No content There are no playable files in the selected folder.
No device The unit cannot detect the USB device.
Please wait The unit is preparing for connecting to the network.
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
The unit cannot be operated from remote control because the remote
Remote Off
control sensor on the main unit is turned off.
The unit cannot play back the songs stored on the USB device for some
reasons.
Unable to play
The unit cannot play back the songs stored on the PC for some reason.
An overcurrent is flowing through the USB device.
USB Overloaded
Version error Firmware update is failed.
Cause
Configure the sharing settings and select the unit as a device to which music contents are shared (p.94).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (p.49).
Twist the bare wires of the cables firmly and connect to the unit and speakers properly.
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn it on
again.
Change the remote control ID of the unit or the remote control (p.154).
Use the controls on the front panel. To use the remote control, set "REMOTE SENSOR" in the "ADVANCED SETUP"
menu to "ON" (p.154).
Check the song data. If it cannot be played on another device, the song data may be defective.
Check if the format of files you are trying to play is supported by the unit. For information about the formats
supported by the unit, see "Playing back music stored on media servers (PCs/NAS)" (p.94). If the unit supports
the file format, but still cannot play back any files, the network may be overloaded with heavy traffic.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Update the firmware again.
171
En
Remedy