Replacing The Time/Date Battery - Brother PT-P950NW User Manual

Using the Touch Panel Display (Optional:PA-TDU-003) (PT-P950NW Only)

Replacing the Time/Date Battery

A time/date battery is provided to maintain the settings for the internal clock. The battery will be consumed
even if the P-touch Label Printer is not used for a long period of time.
Important
• Use only recommended batteries in the P-touch Label Printer. Other batteries may cause damage to the
P-touch Label Printer.
• When storing or discarding the battery, wrap it (for example with cellophane tape) to prevent it from
short-circuiting.
(Battery insulation example)
1 Cellophane tape
2 Time/date battery
• We recommend replacing the battery every two years.
• If the clock is reset while power is supplied to the P-touch Label Printer, replace this battery. When
replacing the battery, buy a CR2032 battery (recommended manufacturers: Hitachi Maxell, Ltd., FDK
Corporation).
• Dispose of the battery at an appropriate collection point, not in the general waste stream. In addition, be
sure to observe all applicable federal, state, and local regulations.
a
Press and hold the
P-touch Label Printer from the AC power outlet. If the rechargeable Li-ion battery (optional) is installed,
remove the rechargeable battery.
b
Using a coin or similar object, slowly turn the time/date battery cover in the direction of the arrow on the
battery cover until it stops, and then remove the time/date battery cover.
(Power) button to turn off the P-touch Label Printer, and then disconnect the
1
2
24
24
222