D-Link DIR-822 User Manual page 168

DIR-822 AC1200 Wi-Fi Router
User Manual
You can specify the following parameters:
Parameter
Open access from any
external host
IP version
IP address
Mask
Public port
Protocol
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, click the link to the relevant rule. On the opened page, change the
needed parameters and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Delete button. Also you can remove a rule on the editing page.
Select the checkbox to allow access to the router for any host. When
the checkbox is selected, the IP version drop-down list is
displayed on the page, and the IP address and Mask fields are not
available for editing.
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
A host or a subnet to which the rule is applied. You can specify an
IPv4 or IPv6 address.
For the IPv4-based network only.
The mask of the subnet.
For the IPv4-based network only.
An external port of the router. You can specify only one port.
The protocol available for remote management of the router.
Page 168 of 212
Configuring via Web-based Interface
Description