Changing Batteries And Notices; Emergency Operation - Kelvinator KSV25HRD User Manual

Changing batteries and notices

1 Push the back cover of wireless remote control.
(As shown in Fig 1.)
2 Take out the old batteries.
3 Insert two new AAA1.5V dry batteries, and pay attention to the
polarity. (As shown in Fig 2.)
4 Attach the back cover of wireless remote control.
NOTE:
• When changing the batteries, do not use old or varied
batteries, otherwise, it may cause problems with the remote
control.
• If the remote control is not used for a long time, please remove
the batteries as old batteries may leak or corrode and damage
the remote controller.
• To avoid interference, the remote should be placed 1m away
from the TV or stereo equipment.
• For correct operation the remote control should be placed
within visible range of the air conditioner.
• If the remote control does not operate normally, please
remove and refit the batteries. If abnormal operation
continues, replace with new batteries.
• To operate the air conditioner, please point the remote control
at the indoor unit in order to improve the sensitivity of the main
unit.
Fig.1
Fig.2 3
10
Changing batteries / emergency operation
2
1
4

Emergency operation

When the remote control is lost or damaged, please use the
manual switch on the main unit. In that case, the unit will operate in
AUTO mode and the temperature setting or fan speed can not be
changed.
The manual switch can be operated as below:
Turn on the unit
Press AUTO/STOP button to enter AUTO mode.
The air conditioner will select the mode (COOL, HEAT, FAN)
automatically according to the room temperature for reaching best
comfort.
Turn off the unit
Press the AUTO/STOP button to switch off the unit.
When AUTO mode is activated, if room temperature is greater
than 25ºC, the unit will go into cooling mode and cool to 25ºC. If
room temperature is lower than 20ºC, the unit will go into HEATING
mode and heat to 20ºC. If the room temperature is between 20ºC
to 25ºC, the unit will run on FAN mode.
This switch is to be used only when the remote control
is missing.
AUTO SWITCH