Kelvinator KSV25HRD User Manual page 8

Features of the remote control
3
8
11
9
4
1
2
The lower 12
buttons are
revealed by
sliding the panel
downwards
1 Clock Button
The clock timer uses a 12 hour clock mode.
Press this button to set the clock. When the clock signal blinks,
you can press or button to set the time you want, when
hold the or button more than 2 seconds, the numbers
increase or decrease by 10 per 0.5 seconds. While the clock
symbol is blinking, press the clock button again or after 5
seconds with no operation, the clock symbol will stop blinking
and the time is set. Please note the default time for the
remote is 12:00 pm and it will revert to this when the battery is
changed. When the clock symbol
the actual time, when the symbol is not shown, the numbers
are for the timer.
8
Remote control features
12
5
10
6
7
shows, the numbers are
2 LIGHT Button
Press this button while the air conditioner is operating to
switch the indicating lights of the indoor unit on or off. The
normal condition at start up is on.
3 TURBO Button
Pressing this button while the air conditioner is
operating will put the fan into the high speed turbo mode. The
indicator on the remote control will show. Turbo mode will be
cancelled if the mode or fan speed
is changed.
4 X-FAN Button
Pressing X -FAN button in COOL or DRY mode, the icon
is displayed and the indoor fan will continue operation for 2
minutes in order to dry the indoor unit even though you have
turned off the unit.
5 ION-FILTER Button
Press this button to turn the cold plasma function on and
off.
6 TIMER-ON Button
Setting the Timer On or start time, press the Timer On button
and the "ON" symbol will flash in the display. Press the
symbol to adjust the start time. Holding the button down will
scroll more rapidly through the start time display. Pressing the
Timer On button again will cancel the timer on function.
NOTE: After selecting the desired time wait 5 seconds and the
ON symbol will display permanently. Default times for timer on
and off are 8:00am and 5:00pm.
7 TIME-OFF Button
Press this key to enter into TIMER OFF setup, in which case the
OFF icon will blink. The method of setting is the same as for
TIMER ON.
8 SWING V Button
Press this button to enable or disable the vertical
swing function. When disabling the vertical swing function the
guiding louver will stay at its last position.
9 SWING H Button
Press this button to enable or disable the horizontal
swing function. When disabling the horizontal swing function
the guiding louver will stay at its last position.
or