Changing Batteries And Notices; Emergency Operation - Kelvinator KSV35NRC User Manual

Changing batteries and notices

1 Push the back cover of wireless remote control.
(As shown in Fig 1.)
2 Take out the old batteries.
3 Insert two new AAA1.5V dry batteries, and pay attention
to the polarity. (As shown in Fig 2.)
4 Attach the back cover of wireless remote control.
Note:
• W hen changing the batteries, do not use old or varied
batteries, otherwise, it may cause problems with the
remote control.
• I f the remote control is not used for a long time, please
remove the batteries as old batteries may leak or corrode
and damage the remote controller.
• T o avoid interference, the remote should be placed 1m
away from the TV or stereo equipment.
• F or correct operation the remote control should be
placed within visible range of the air conditioner.
• I f the remote control does not operate normally, please
remove and refit the batteries. If abnormal operation
continues, replace with new batteries.
• T o operate the air conditioner, please point the remote
control at the indoor unit in order to improve the
sensitivity of the main unit.
Fig.1
2
Fig.2 3
6 Changing batteries/Energy operation Kelvinator Air Conditioning

Emergency operation

When the remote control is lost or damaged, please use
the manual switch on the main unit. In that case, the unit will
operate in AUTO mode and the temperature setting or fan
speed can not be changed.
The manual switch can be operated as below:
Turn on the unit
Press AUTO/STOP button to enter AUTO mode.
The air conditioner will select the mode (COOL, HEAT,
FAN) automatically according to the room temperature for
reaching best comfort.
Turn off the unit
Press the AUTO/STOP button to switch off the unit.
The operation mode is seen in the following table.
Mode
1 AUTO
AUTO
AUTO
This switch is to be used only when the remote control
is missing.
4
AUTO SWITCH
Model Temperature setting
COOLING 25°C (COOL, FAN)
HEATING PUMP 25°C (COOL, FAN)
HEATING PUMP 20°C (HEAT)
Airflow rate
AUTO
AUTO
AUTO