Leds - Cisco IE 2000 Installation Manual

Table 2 SFP Module Maximum Operating Temperature by Model (continued)
SFP Module
Extended temperature SFPs
23 to 185°F (-5°C to 85°C)
For minimum software requirements, refer to the Release Notes for your platform.
For an up-to-date list of supported SFP models for Cisco Industrial Ethernet switches, see
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#wp1
38176
For installation instructions, see your SFP module documentation and the
For cable specifications, see the
SFP Module Patch Cable
The switch uses an SFP-module patch cable, a 0.5-meter, copper, passive cable with SFP module connectors at each
end (see Figure 8 on page
Figure 8 SFP-Module Patch Cable
See the Installing and Removing SFP Modules, page 64
You can order this cable (part number CAB-SFP-50CM=).

LEDs

You can use the LEDs to monitor the switch status, activity, and performance.
page -22 show the front panel LEDs.
Model

SFP-GE-L with DOM support

SFP-GE-S with DOM support

SFP-GE-T

SFP-GE-Z with DOM support

GLC-LH-SMD with DOM support

GLC-EX-SMD with DOM support

GLC-SX-MMD with DOM support

GLC-TE

GLC-ZX-SMD with DOM support
SFP Module Cables, page
18). The patch cable connects two switches in a cascaded configuration.
Installing and Removing SFP Modules, page
88.
for information about using the SFP module patch cable.
Figure 9 on page 19
18
64.
and Table 9 on