Flash Memory Card - Cisco IE 2000 Installation Manual

Table 10 PoE Status LED
Color
Off
Green
Alternating green and amber
Flashing amber
Amber

Flash Memory Card

The switch supports a flash memory card that makes it possible to replace a failed switch without reconfiguring the new
switch. The slot for the flash memory card is on the front of the switch. The flash card is hot swappable and can be
accessed on the front panel. A cover protects the flash card and holds the card firmly in place. The cover is hinged and
closed with a captive screw. This prevents the card from coming loose and protects against shock and vibration.
For more information on inserting and removing the flash memory card, see the
Card (Optional), page
Note: The replacement SD card part number is SD-IE-1GB.
Rear Panel
The rear panel of the switch has a latch for installation on a DIN rail. See
to move down to position the switch over a DIN rail and return to the original position to secure the switch to a DIN rail.
PoE Status
PoE is off. If the powered device is receiving power from a non-PoE power source, the
port LED is off even if the powered device is connected to the switch port.
PoE is on. The port LED is green only when the PoE port is providing power.
PoE is denied because providing power to the powered device will exceed the switch
power capacity.
PoE is off due to a fault.
Caution: Non-compliant cabling or powered devices can cause a PoE port fault. Use
only standard-compliant cabling to connect Cisco pre-standard IP Phones and
wireless access points or IEEE 802.3af-compliant devices. You must remove any cable
or device that causes a PoE fault.
PoE for the port is disabled. (PoE is enabled by default.)
31.
Installing or Removing the Flash Memory
Figure 11 on page
23
24. The latch is spring-loaded