Table of Contents
Advertisement
Figure 25 Inserting Wires in the Power Connector
1
2
1
Power source positive connection
2
Power source return connection
7.
Use a ratcheting torque flathead screwdriver to torque the power connector captive screws (above the installed wire
leads) to 2 in-lb (0.23 N-m). See
Figure 26 on page
48.
Note:
Do not over-torque the power connector's captive screws. The torque should not exceed 2 inch-lbs (0.23
N-m).
47
Hide quick links:
Advertisement
Chapters
Table of Contents
