If the unit is installed on brackets to the wall, it is advised to use the
EKFT008CA option kit and to install the unit as follows:
b b
(mm)
a Maximum snowfall height
b EKFT008CA option kit
EHBH04+08 + ERLQ004~008
Daikin Altherma - Low Temperature Split
4P313774-1 – 2012.05
7.2.2 To install the outdoor unit
CAUTION
Do NOT remove the protective cardboard before the unit is
installed properly.
1
Lift the outdoor unit as described in To remove the accessories
from the outdoor unit.
2
Install the outdoor unit as follows:
a
1
a Air outlet
NOTICE
The pedestal MUST be aligned with the backside of the U-
beam.
3
Remove the protective cardboard and instruction sheet.
b
a
a Protective cardboard
b Instruction sheet
7.2.3 To prepare drain work
Avoid installation places where water leaking from the unit due
to a blocked drain pan, cause damage to the location.
Make sure that condensation water can be evacuated properly.
Install the unit on a base to make sure that there is a proper
drainage in order to avoid ice accumulation.
Prepare a water drainage channel around the foundation to
drain waste water surrounding the unit.
Avoid drain water flowing over the footpath, so that it does not
become slippery in case of ambient freezing temperatures.
7 Installation
a
2
2x
Installer reference guide
28